Chapter 7 – UT Screens
41
Icon Description
Sections
The number of equal width sections that the actual
working width is divided into.
Cut out
height
Cut out height
Sets the header (table) height at which the sensor will
start/stop recording harvest data. The current position of
the header is shown on the following icon:
To set the cut out height:
1. Ensure the required crop type is selected.
2. Move the header height to just above the required
cutting height.
3. Press to set the cut out height.
This height should be set for each crop type.
Status The voltage signal from the header (table) height sensor.
To Next Page
Loading...