48
Auto Cal
Note: This process is only required if a new combine type is being
used that does not have the PC Points supplied on the calibration
spreadsheet. Alternatively, a barn test can be used to determine the PC
Points for a new combine type.
This procedure should be used if it is not possible to do a barn test.
To perform an auto calibration:
The following AUTOCAL procedure calibrates the yield sensor(s) in
a field test under real harvest conditions.
Position the combine in an area of the field with a good crop (wheat or
barley will give the best results) where there are no tramlines or
flattened patches. This will obviously affect the quantity of crop going
through the machine so the test must be carried out on a continuous
section of crop.
1. Set the Tare. See Set tare screen, page 43.
2. Select the button.
To Next Page
Loading...