50
Fact. A: This setting should not be changed.
The Gain, Offset and % Correction values calibrate the moisture
sensor to enable accurate readings for crops up to a certain limit of
moisture content. They are specific to each crop, so you must first
select the required crop.
Gain and Offset
Gain and Offset have been determined for each pre-programmed crop
type by a series of calibration tests. They are pre-programmed and do
not normally need altering.
Crop Gain Offset
Wheat 7.031 4.100
Barley 3.747 10.200
Oats 5.520 8.400
Oilseed rape 2.117 10.000
Linseed 4.000 5.000
Beans 4.013 7.100
Peas 4.000 5.000
Maize 7.907 2.000
Crop1 7.037* 2.000*
Crop2 7.037* 2.000*
*Default values – may need to be adjusted depending on crop type
assigned.
% Correction
Note: This setting is the same as the setting on the Crop
Settings screen. See page 38.
Voltage
The voltage reading is for diagnostic purposes to indicate that the
sensor is operating.
To Next Page
Loading...