EasyManua.ls Logo

Topcom YieldTrakk YM-1 - Page 8

Topcom YieldTrakk YM-1
75 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
iv
The receiver contains an internal radio-modem. This can potentially send signals.
Regulations vary between countries, so check with the dealer and local regulators for
information on licensed and unlicensed frequencies. Some may involve subscriptions.
Radio and Television Interference
This computer equipment generates, uses, and can radiate radio-frequency energy. If it
is not installed and used correctly in strict accordance with TOPCON Precision
Agriculture instructions, it may cause interference with radio communication.
You can check if interference is being caused by this equipment by turning the Topcon
equipment off to see if the interference stops. If the equipment is causing interference
to a radio or other electronic device, try:
Turning the radio antenna until the interference stops
Moving the equipment to either side of the radio or other electronic device
Moving the equipment farther away from the radio or other electronic device
Connecting the equipment to another circuit that is not linked to the radio.
To reduce potential interference operate the equipment at the lowest gain level that
will allow successful communication.
If necessary contact your nearest Topcon Precision Agriculture dealer for assistance.
Note: Changes or modifications to this product not authorized by TOPCON Precision
Agriculture could void the EMC compliance and negate authority to operate the
product.
This product was tested for EMC compliance using Topcon Precision Agriculture
peripheral devices, shielded cables and connectors. It is important to use Topcon
Precision Agriculture devices between system components to reduce the possibility of
interference with other devices
General Safety
DANGER: It is essential that the following information and the product
specific safety information is read and understood.
Most incidents arising during operation, maintenance and repair are caused by a failure
to observe basic safety rules or precautions. Always be alert to potential hazards and
hazardous situations.
Always follow the instructions that accompany a Warning or Caution. The information
these provide aims to minimize risk of injury and/or damage to property.
In particular follow instructions presented as Safety Messages.