Topcon GTS-239N - Page 78

6-28
6 SPECIAL MODE (Menu Mode)
z Input SPIRAL data
Operating procedure Operation Display
1 To input SPIRAL data, press the [F3] key. *1)
[F3]
2 Input RADIUS.
3 Press the [ENT] key.
4 Input LENGTH.
5 Press the [ENT] key.
6 Select TURN(direction of turn): RIGHT or LEFT.
7 Press the [ENT] key.
Input
RADIUS
[ENT]
Input
LENGTH
[ENT]
Select
[F1]
(LEFT)
or
[F2]
(RIGHT)
[ENT]
8 Select DIR(direction): IN(entrance) or OUT(exit).
9 Press the [ENT] key.
Select
[F1]
(IN)
or
[F2]
(OUT)
[ENT]
*1) SPIRAL cannot be input as the first data.
F1:LINE
F2:CURVE
F3:SPIRAL
F4:POINT
SPIRAL 03
R = 0.000 m
L : 0.000 m
––– ––– [CLR][ENT]
SPIRAL 03
R : 100.000 m
L = 0.000 m
––– ––– [CLR][ENT]
SPIRAL 03
TURN > RIGHT
DIR : IN
LEFT RIGHT ––– ENTER
SPIRAL 03
TURN : LEFT
DIR > IN
IN OUT ––– ENTER
<SET!>