46
PREPARATIONS
SETTING VD
In VD setting, contact (0) or glasses (12mm or 13.75mm) can be selected. Before shipment, it
is set to glasses (12mm).
1 Press the of the control panel and get the “SETTING MENU SCREEN”.
2 Press the and invert “VD”.
VD figures are displayed on the right.
3 Press the and invert the desired “VD” figure.
4 Press the ,and the cursor moves to the next item(CONT.MEAS.) .
SETTING CONT.MEAS.
Continuous measurement can be set. Before shipment, it is set to “NO” (normal
measurement).
1 Press the of the control panel and get the “SETTING MENU SCREEN”.
2 Press the and invert “CONT.MEAS.”.
“YES” and “NO” are displayed on the right.
3 Press the and invert “YES” for continuous measurement.
4 Press the ,and the cursor moves to the next item(OUTPUT DATA).
MENU SWITCH
MEASUREMENT SWITCH
PRINT SWITCH
MEASURE SWITCH ITEM
PRINT SWITCH SELECT
STEP
AXIS STEP
VD
CONT.MEAS.
OUTPUT DATA
SETTING MENU
12.00
0.00
13.75
MEASUREMENT SWITCH
MENU SWITCH
MEASUREMENT SWITCH
PRINT SWITCH
MEASURE SWITCH ITEM
PRINT SWITCH SELECT
STEP
AXIS STEP
VD
CONT.MEAS.
YES
OUTPUT DATA
NO
SETTING MENU
MEASUREMENT SWITCH
To Next Page
Loading...
