16
ASSEMBLY PROCEDURE
SECURING THE BINOCULAR TUBES
1 Align the pin of the microscope unit with the groove on the binocular tubes, and fit the screw with
a hexagon wrench.
In the model without excitor/barrier filter, fit binocular tube with the fixing screw.
SECURING THE ILLUMINATION UNIT
Loosen the microscope arm locking-knob of the base unit, manually turn the shaft and tilt the guide rod-
shaft index 30-60°, then refasten the microscope-arm locking-knob.
2 Loosen the fixing screw on the outside of the fitting cavity of the illumination unit with a screw-
driver. Align indices and slowly lower the illumination unit onto the shaft of the base unit.
NOTES
Make sure you do not touch the lens surfaces.
NOTES
While assembling the illumination unit, take care not to get your fingers caught.
To Next Page
Loading...
