6
Preventing Electric Shock and Fire.
To avoid fire in the event of an instrument malfunction, immediately turn OFF the power switch ( ) and
disconnect the power cord from the instrument if you see smoke coming from the instrument, etc.
Don't install the instrument where it is difficult to disconnect the power cord from the instrument. Ask
your dealer for service.
CAUTIONS
Ensuring the Safety of Patients and Operators
Be careful not to let the patient touch this instrument. The patient's hand may be pinched by a movable
part.
To avoid burns caused by heat, do not replace the lamp with a new one immediately after it goes off.
To avoid injury to the patient's head, incline the illumination unit slowly while holding the base unit.
When operating the base unit, please note the following:
•Beware of catching fingers in the moving parts.
•Avoid hitting the patient's eyes or nose.
Preventing Electric Shock and Burn
To avoid injury or fire caused by electric shock, turn off the power switch and unplug the power cord
when not in use.
To avoid injury caused by electric shock, turn off the power switch when replacing the lamp.
Electromagnetic Compatibility (EMC)
This instrument has been tested (with 100/120/230V) and found to
comply with IEC60601-1-2 Ed.3.0:
2007as class B(classified according to CISPR11).
This instrument radiates radio frequency energy within standard and may affect other devices in the
vicinity.
If you have discovered that turning on/off the instrument affects other devices, we recommend you
change its position, keep a proper distance from other devices, or plug it into a different outlet.
Please consult your authorized dealer if you have any additional questions.
To Next Page
Loading...
