Topcon X30 - Page 15

xi
Chapter 4 – Calibration 45
4.1. Product calibration modes 45
4.1.1. Dynamic mode 45
4.2. Performing calibration (with or without load cells) 47
4.2.1. Product flow factor – check calibration routine 49
4.3. Nudge calibration 52
4.4. Static mode calibration 53
4.5. Valve calibration 54
Chapter 5 – Operation 57
5.1. Opening auto section control 57
5.2. Using the master switch 59
5.3. Variable rate control 60
5.3.1. If using VRC maps 60
Chapter 6 – Updating Athene Software 65
Chapter 7 – Index 67