Shenzhen Topwisdom Technology Co., Ltd
equipment.
RealSize: The length on the effect drawing designed by the user, normally in whole
numbers but not exceeding the max. travel.
WishSize: The length of the track left by the engraver on the engraved material, which
can be measured by measuring tools.
Fig. 4-18
About the size of the measuring:
Draw a 30*30 rectangle to calculate the resolution. When measuring, the width of the
laser beam needs to be considered. The processed reactangle is as shown in figure
below. Take the measured value of the X axis 34mm, and input 34 into the RealSize
edit box and 30 into the WiseSize edit box. Click ok the program will calculate out the
right resolution. Other Axis is similar. When calculate the resolution of Y, the RealSize
is the length of trace the beam moved.
Fig. 4-19
Test Precision(µm): This parameter is valid when the equipment is provided with the
closed-loop detection system, this parameter finally decides the errors between the
engraved dimensions and the designed dimensions, in this case, only the adjustment
of this parameter rather than the minute changes of the motion resolution will influence
the engraved dimensions.
This parameter is invalid when the equipment is not provided with the closed-loop
detection system. In this case, the minute changes of the motion resolution will directly
influence the engraved dimensions.
To Next Page
Loading...
