Toro 03540 Reelmaster 5200-D - Setup

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
1
No parts required
–
Connect the Battery
Locking hood switch
1
Lock washer
1
Nut 1
Key 2
Hood latch bracket
1
Bolt (1/4 x 3/4 inch)
2
Flat washer (1/4 inch)
2
2
Locknut (1/4 inch)
2
Mount the hood latch.
Flange-head bolt (5/16 x 5/8 inch)
1
3
Flange-head bolt (5/16 x 3/4 inch)
1
Replace the panel fasteners (CE
only).
4
No parts required
–
Adjust the tire pressure.
5
Cutting unit (sold separately)
5
Install the cutting units
6
No parts required
–
Adjust the turf compensation
spring.
7
No parts required
–
Adjust the lifted height of the
outer front cutting units (enable
position).
8
Rear weights (size varies with
conguration).
Varies
Install rear weights.
CE decal
1
9
Blank service decal
1
Install the CE Decals
Operator’s Manual
1
Engine Operator’s Manual
1
Parts Catalog
1
CE certicate
2
Safety Video
1
10
Diagnostic ACE display overlay
1
Read the Operator’s Manual and
watch the video before operating
the machine.
Note: Deter mine the left and right sides of the
mac hine from the nor mal operating position.
13