Toro 03540 Reelmaster 5200-D - 4 Adjusting the Tire Pressure; 5 Installing the Cutting Units

Figure 5
1. Floor panel 2. Access panel
2. R e place the floor panel fastener with a
flang e-head bolt (5/16 x 5/8 inc h) supplied in
loose par ts ( Figure 5 ).
3. R e place the access panel fastener with a
flang e-head bolt (5/16 x 3/4 inc h) supplied in
loose par ts ( Figure 5 ).
Step
4
Adjusting the Tire Pressure
No Parts Required
Procedure
T he tires are o v er -inflated for shipping . T herefore ,
release some of the air to reduce the pressure .
Cor rect air pressure in the front and rear tires is 10
to 15 psi (69 to 103 kP a).
Important: Maintain ev en pr essur e in all
tir es to ensur e unif or m contact with the turf.
Step
5
Installing the Cutting Units
Parts needed for this step:
5
Cutting unit (sold separately)
Procedure
1. R emo v e the cutting units from the car tons .
Assemble and adjust the as described in the
cutting unit Operator’ s Manual .
2. If y ou will be using bask ets on the cutting units ,
use the c har t belo w ( Figure 6 ) to deter mine the
locations at whic h y ou need to mount bask et
guides to the cutting unit car rier frames . If y ou
will not be using bask ets , proceed to ste p 4 .
Figure 6
3. Mount a bask et guide ( Figure 7 ) to the
appropriate side of eac h cutting unit car rier
frame ( Figure 8 ) with a bolt (5/16 x 1-3/4
inc hes), flat w asher , and loc k w asher or
fasteners previously remo v ed, as sho wn in
Figure 7 .
16