3. Loosen the inner loc kn ut securing the eye bolt
to the spring anc hor plate ( Figure 62 ).
Figure 62
1. Spring anchor plate 4. Outer locknut
2. Eye bolt 5. Shorten distance to
decrease time required
to stop machine.
3. Inner locknut
4. R otate the outer loc kn ut cloc kwise until the
distance betw een the inside of the eye bolt
loop and the inside of the spring anc hor plate
is shor tened 1/8 inc h, as sho wn in Figure 62 .
Tighten the inner loc kn ut.
5. Operate the mac hine and c hec k the stopping
distance . R e peat procedure if required.
Note: Shor tening the distance betw een the
inside of eye bolt loop and inside of the spring
anc hor plate increases the pedal force on the
traction pedal. T herefore , do not o v er adjust.
Changing the Transmission
Fluid
Chang e the transmission fluid after ev er y 800
hours of operation or ann ually , whic hev er occurs
first, in nor mal conditions .
1. P osition the mac hine on a lev el surface , lo w er
the cutting units , stop the engine , eng ag e the
parking brak es , and remo v e the k ey from the
ignition switc h.
2. Clean the area around the suction line on the
bottom of the transmission ( Figure 63 ) and
place a drain pan under the line .
Figure 63
1. Transmission suction line 2. Transmission oil lter
3. R emo v e the line from the transmission
allo wing the fluid to drain into the drain pan.
4. Install the suction line to the transmission.
5. Fill the transmission with oil; refer to Chec king
the T ransmission Fluid in Operation , pag e 26 .
6. Before star ting the engine , after c hanging the
transmission fluid, disconnect the r un (ETR)
solenoid on the engine , and crank the engine
for 15 seconds . T his allo ws the c harg e pump
to fill the transmission with fluid before y ou
star t the engine .
Replacing the Transmission
Oil Filter
R e place the transmission filter initially after
the first 200 operating hours and ev er y 800
operating hours or ann ually , whic hev er occurs
first, thereafter .
Only the T oro re placement filter (P ar t No .
110-4146) can be used in the h y draulic system.
Important: Use of an y other filter may v oid
the w ar ranty on some components.
1. P osition the mac hine on a lev el surface , lo w er
the cutting units , stop the engine , eng ag e the
parking brak es , and remo v e the k ey from the
ignition switc h.
2. Clean the area around the filter mounting area
( Figure 63 ) and place drain pan under filter .
3. R emo v e the filter .
4. Lubricate the g ask et on the new filter with
h y draulic oil.
50
To Next Page
Loading...
