Service Interval Chart
Figure 41
1. Read the Operator’s Manual.
If y ou lea v e the k ey in the ignition s witch, someone could accidentl y star t the engine and
seriousl y injur e y ou or other bystander s.
R emo v e the k ey fr om the ignition bef or e y ou do an y maintenance.
Lubrication
Greasing the Bearings and
Bushings
If y ou operate the mac hine under nor mal
conditions , lubricate all g rease fittings for the
bearings and bushings after ev er y 50 hour s of
operation with No . 2 General Pur pose Lithium
Base Grease . Lubricate bearings and bushings
immediatel y after ev er y w ashing, reg ardless of
the inter v al listed.
T he g rease fitting locations and quantities are as
follo ws:
• 3 fittings on the engine dri v e shaft ( Figure 42 )
Figure 42
• 2 fittings on eac h cutting unit car rier frame and
pi v ot (10 total) ( Figure 43 )
42
To Next Page
Loading...
