Figure 32
Decal 98-9342
1. Reel—height of cut 4. Machine speed
2. Reel—mow and backlap 5. Rear reels circuit controls
3. Read the Operator’s
Manual.
6. Front reels circuit controls
4. T o set the reel speed, rotate knobs ( Figure 33 )
until the indicator ar ro ws are in line with the
n umber designating the desired setting .
Figure 33
1. Reel speed control knobs
Note: T he reel speed can be increased or
decreased to compensate for turf conditions .
Adjusting the Lift Arm Down
Pressure
Y ou can adjust the do wn pressure spring on eac h
cutting unit lift ar m to compensate for different
turf conditions . Increased do wn pressure will
help k ee p the cutting units on the g round when
mo wing at higher speeds and helps maintain a
unifor m height-of-cut in rough conditions or in
areas of thatc h build up .
Y ou can adjust eac h do wn pressure spring to one
of four settings . Eac h increment increases or
decreases do wn pressure on the cutting unit b y 8
lb (3.6 kg).
1. P osition the mac hine on a lev el surface , lo w er
the cutting units , stop the engine , eng ag e the
parking brak es , and remo v e the k ey from
ignition switc h.
2. R emo v e the floor plate in front of the seat and
open the hood to g ain access to all 5 springs .
T he springs ar e under tension.
Use caution when adjusting them.
3. Place an open end wrenc h on the hex shaft of
the spring brac k et ( Figure 34 ).
32
To Next Page
Loading...
