Toro 03540 Reelmaster 5200-D - Checking the Rear Axle; Lubricant

Note: T oro will not assume responsibility for
damag e caused b y improper substitutions , so use
only products from re putable man ufacturers who
will stand behind their recommendation.
High Viscosity Index/Low Pour Point Anti-wear
Hydraulic Fluid, ISO VG 46
Material Properties:
Viscosity, ASTM D445
cSt @ 40°C 55 to 62
cSt @ 100°C 9.1 to 9.8
Viscosity Index ASTM
D2270
140 to 152
Pour Point, ASTM D97
-35°F to -46°F
Industry Specications:
API GL-4, AGCO Poweruid 821 XL, Ford
New Holland FNHA-2-C-201.00, Kubota UDT,
John Deere J20C, Vickers 35VQ25 and Volvo
WB-101/BM
Note: Many h y draulic fluids are almost colorless ,
making it difficult to spot leaks . A red dye additi v e
for the h y draulic system oil is a v ailable in 2/3 oz.
(20 ml) bottles . One bottle is sufficient for 4-6 g al
(15-22 1) of h y draulic oil. Order par t no . 44-2500
from y our authorized T oro distributor .
1. P osition the mac hine on a lev el surface , lo w er
the cutting units , and stop the engine .
2. Clean the area around the filler nec k and cap
of the h y draulic tank ( Figure 28 ).
Figure 28
1. Hydraulic tank cap
3. R emo v e the cap from the filler nec k.
4. R emo v e the dipstic k from the filler nec k and
wipe it with a clean rag .
5. Inser t the dipstic k into the filler nec k; then
remo v e it and c hec k the fluid lev el.
T he fluid lev el should be within 1/4 inc h (6
mm) of the mark on the dipstic k.
6. If the lev el is lo w , add the appropriate fluid to
raise the lev el to the full mark.
7. Install the dipstic k and cap onto the filler nec k.
Checking the Rear Axle
Lubricant
Note: T his procedure is for Model 03544 only .
T he rear axle of Model 03544 has three se parate
reser v oirs whic h use SAE 80W -90 w eight g ear
lube . Although the axle is shipped with lubricant
from the factor y , c hec k the lev el before operating
the mac hine .
1. P osition the mac hine on a lev el surface .
2. R emo v e the 3 c hec k plugs from axle ( Figure 29
and Figure 30 ) and mak e sure lubricant is up to
bottom of eac h hole .
Figure 29
1. Check plug 2. Fill plug
Figure 30
1. Left check plug (rear of the axle)
3. If the lev el is lo w , remo v e the center fill plug
and add enough lubricant to bring the lev el up
to the bottom of the center c hec k plug hole .
29