Step
2
Mounting the Hood Latch
(CE Units Only)
Parts needed for this step:
1
Locking hood switch
1
Lock washer
1 Nut
2 Key
1
Hood latch bracket
2
Bolt (1/4 x 3/4 inch)
2
Flat washer (1/4 inch)
2
Locknut (1/4 inch)
Procedure
1. R emo v e the plug from the hole in the left front
cor ner of the hood ( Figure 3 ).
Figure 3
1. Hood plug
2. Open the hood.
3. Mount the loc king switc h to the hood with
a loc k w asher and n ut. P osition the switc h
with the latc h to w ard the front of the mac hine
( Figure 4 ).
Figure 4
1. Locking switch 2. Latch bracket
4. Loosely mount the latc h brac k et to the radiator
suppor t with 2 bolts (1/4 x 3/4 inc h), flat
w ashers , and loc kn uts ( Figure 4 ).
5. Adjust the latc h brac k et, until it is aligned with
the switc h latc h, then tighten the bolts .
6. R otate the latc h to the loc k ed and unloc k ed
positions with the k ey . R emo v e the k ey and
store it in a memorable place .
7. Close the hood.
Step
3
Replacing the Panel
Fasteners (CE Units Only)
Parts needed for this step:
1
Flange-head bolt (5/16 x 5/8 inch)
1
Flange-head bolt (5/16 x 3/4 inch)
Procedure
1. R emo v e the fasteners securing the left front
cor ner of the floor panel and the left end of
the access panel to the frame ( Figure 5 ).
15
To Next Page
Loading...
