Figure 7
1. Carrier frame 2. Basket guide
4. Install a roll pin ( Figure 8 ) into the hole in the
appropriate side of eac h cutting unit car rier
frame ( Figure 6 ).
Figure 8
1. Carrier frame 3. Basket bracket
2. Roll pin 4. Basket collar
5. Align the mounting shaft of the cutting unit
with the pi v ot tube on the car rier frame . Inser t
the shaft into the tube ( Figure 9 ).
Figure 9
1. Cutting unit mounting
shaft
4. Flat washer
2. Carrier frame pivot tube 5. Lock washer
3. Thrust washer 6. Bolt
6. Secure the shaft in the pi v ot tube with a thr ust
w asher , flat w asher , loc k w asher , and bolt
( Figure 9 ).
7. Assemble the mounting n uts for the reel dri v e
motor to eac h cutting unit ( Figure 10 ). Lea v e
appro ximately 1/2 inc h (1.25 cm) of threads
exposed on eac h mounting stud.
Figure 10
1. Reel drive motor
2. Mounting nuts
8. Coat the spline shaft of the motor with clean
g rease and install the motor b y rotating it
cloc kwise so that the motor flang es clear the
studs . R otate the motor countercloc kwise until
the flang es encircle the studs and tighten the
17
To Next Page
Loading...
