Maintenance Service
Interval
Maintenance Procedure
Every 400 hours
• Check the fuel lines and connections for deterioration, damage, or loose
connections.
• Replace the fuel lter canister.
• Replace the fuel prelter.
• Check the traction linkage movement.
• Check the engine RPM (idle and full throttle).
Every 800 hours
• Change the transmission uid.
• Replace the transmission lter.
• Change the rear axle lubricant (Model 03544 only)
• Check the rear wheel toe-in.
• Change the hydraulic uid.
• Change the hydraulic lter (sooner if the service interval indicator on the
lter head is in the Red zone).
• Pack the rear wheel bearings (2-wheel drive only)
• Adjust the engine valves (refer to the engine Operator’s Manual)
Every 2 years
• Drain and clean the fuel tank.
• Flush and replace the cooling system uid.
• Drain and ush the hydraulic tank.
• Replace all moving hoses.
• Replace the safety interlock switches
Important: R efer to y our Engine Operator’ s Man ual f or additional maintenance pr ocedur es.
40
To Next Page
Loading...
