Toro 07390 Workman HDX-Auto - Setup Procedures; Installing the Steering Wheel

Setup
LooseParts
Usethechartbelowtoverifythatallpartshavebeenshipped.
ProcedureDescription
Qty.
Use
Steeringwheel
1
Cover
1
1
Washer(5/8inch)
1
Installthesteeringwheel.
ROPSframe
1
2
Flange-headbolt(1/2x1-1/4inch)
6
MounttheROPS(RolloverProtection
System).
3
Nopartsrequired
–
Connectthebattery.
4
Nopartsrequired
–
Connectthecontinuouslyvariable
transmissionintakeduct.
5
Nopartsrequired
–
Checktheengineoil,transaxle/hydraulic
uid,coolant,andbrakeuidlevels.
MediaandAdditionalParts
Description
Qty.
Use
Operator'sManual
1
Readbeforeoperatingthevehicle.
PartsManual1
Usetoreferencepartnumbers.
OperatorTrainingMaterial
1
Viewbeforeoperatingthemachine.
CVTKit121-9853
1
ConnectingtheCVTIntakeDuct(TCandHModelsOnly)
CVTAdapter127-8750
1
ConnectingtheCVTIntakeDuct(TCandHModelsOnly)
Note:Determinetheleftandrightsideofthemachinefromthenormaloperatingposition.
1
InstallingtheSteeringWheel
(TCandHModelsonly)
Partsneededforthisprocedure:
1
Steeringwheel
1
Cover
1
Washer(5/8inch)
Procedure
1.Ifthecoverisinstalled,removetheitfromthehubof
thesteeringwheel(Figure3).
2.Removethenutfromthesteeringshaft(Figure3).
3.Slidethesteeringwheelandwasherontothesteering
shaft(Figure3).
4.Securethesteeringwheeltotheshaftwiththenutand
tightenitto27–34N-m(20-25ft-lb).
5.Installthecoveronthesteeringwheel(Figure3).
12