Toro 07390 Workman HDX-Auto - Using the Bed Safety Support; Removing the Full Bed

UsingtheBedSafetySupport
Important:Alwaysinstallorremovethebedsupport
fromtheoutsideofthebed.
1.Raisethebeduntiltheliftcylindersarefullyextended.
2.Removethebedsupportfromthestoragebracketson
backoftheROPSpanel(Figure40).
Figure40
1.Bedsupport
3.Pushthebedsupportontothecylinderrod,making
surethatthesupportendtabsrestontheendof
cylinderbarrelandonthecylinderrodend(Figure41).
Figure41
1.Bedsupport3.Bed
2.Cylinderbarrel
4.Whennished,removethebedsupportfromthe
cylinderandinsertitintothebracketsonthebackof
theROPSpanel.
Important:Donottrytolowerbedwithbed
safetysupportoncylinder.
RemovingtheFullBed
Fullbedweight:approximately147.5kg(325lb)
1.Starttheengine.
2.Movethehydraulicliftleverforwardandlowerthe
beduntilthecylinderrodendsarelooseintheslots(
HydraulicLiftLever(page16)).
3.Releasetheliftleverandturnofftheengine.
4.Removethelynchpinsfromtheouterendsofthe
cylinderrodclevispins(Figure42).
Figure42
1.Cylinderrodend
4.Lynchpin
2.Bedmountingplate
5.Rearslot(Fullbed)
3.Clevispin6.Frontslot(2/3bed)
5.Removetheclevispinssecuringthecylinderrodends
tothebedmountingplatesbypushingthepinstoward
theinside(Figure42).
6.Removethelynchpinsandclevispinssecuringthe
pivotbracketstotheframechannels(Figure42).
7.Liftthebedoffthemachine.
Important:Thefullbedweighsapproximately
147.5kg(325lb),sodonottrytoinstallorremove
itbyyourself.Useanoverheadhoistorgetthe
helpof2or3otherpeople.
8.Storethecylindersinthestorageclips.
9.Setthehydraulicliftlockleveronthemachinetothe
Lockposition;referto.
Note:Lockthelevertopreventtheliftcylindersfrom
extending.
36