Toro 07390 Workman HDX-Auto - Connecting the CVT Intake Duct (TC and H Models Only)

Figure5
1.Batterycover
2.Removethebatterycoverfromthebatterybase(Figure
5).
3.Installthepositive-batterycable(red)ontothepositive
(+)terminalofthebatteryandsecurethecablewith
theboltsandnuts(Figure6).
Figure6
1.Insulatorboot
(positive-batterycable)
3.Negative-batterycable
2.Negative-batterypost
4.Slidetheinsulatorbootoverthepositiveterminal.
Note:Theinsulatorbootisusedtopreventapossible
short-to-groundfromoccurring.
5.Installthenegative-batterycable(black)ontothe
negative(–)terminalofthebatteryandsecurethecable
withboltsandnuts.
6.Alignthebatterycovertothebatterybase(Figure5).
7.Squeezethebatterycover,alignthetabstothebattery
base,andreleasethebatterycover(Figure5).
4
ConnectingtheCVTIntake
Duct(TCandHModelsonly)
NoPartsRequired
Procedure
Important:Removetheplasticbagcoveringtheendof
theCVTductbeforestartingtheengineofthemachine.
TheCVTkit121-9853andadapterkit127-8750isrequired
forthisprocedure.
1.Loosenthehoseclampsecuringtheplasticbagatthe
endoftheCVTintakehoseandremovethebag.
Note:Discardplasticbag.
2.Raisethecargoboxbyperformingthefollowing:
A.Settheparkingbrake;refertoParkingBrake
(page16).
B.Starttheengine;refertoStartingtheEngine(page
27).
C.Movethehydraulic-liftleverbackwardtoraisethe
cargobox;refertoHydraulicLiftLever(page16).
D.Shutofftheengine;refertoStoppingtheEngine
(page27).
E.Removethebedsupportfromthestoragebrackets
onbackoftheROPSpanelandinstallthesupport
ontothecylinderrodofthebedliftcylinder;refer
toUsingtheBedSafetySupport(page36).
3.AligntheCVTintakehoseontotheintake-tube
connectoratthebacksideoftheROPSpaneland
tightenthehoseclamp(Figure7).
Figure7
1.CVTintakehose
3.Intake-tubeconnector
2.Hoseclamp
14