Toro 23208HD - Page 25

Changing the Engine Oil
Note: Dispose of the used oil at a recycling center .
1. Start the engine and let it run for 5 minutes.
Note: This warms the oil so that it drains better .
2. Park the machine on a level surface, engage
the parking brake (if applicable), and lower the
grinder .
3. Shut of f the engine and remove the key .
4. Change the oil as shown in ( Figure 30 ).
g242255
g027734
Figure 30
5. Slowly pour approximately 80% of the specied
oil into the ller tube and slowly add the
additional oil to bring it to the Full mark ( Figure
31 ).
g194610
Figure 31
6. Start the engine and drive to a at area.
7. Check the oil level again.
25