Toro 72907 - Page 54

machines do not touch and that both electrical
systems are of f and at the same rated system
voltage. These instructions are for negative
ground systems only .
3. Connect the positive (+) cable to the positive (+)
terminal of the discharged battery that is wired
to the starter or solenoid as shown in Figure 70 .
g012785
Figure 70
1. Positive (+) cable on
discharged battery
5. Booster battery
2. Positive (+) cable on
booster battery
6. Discharged battery
3. Negative (–) cable on the
booster battery
7. Engine block
4. Negative (–) cable on the
engine block
4. Connect the other end of the positive cable to
the positive terminal of the booster battery .
5. Connect the black negative (–) cable to the other
terminal (negative) of the booster battery .
6. Make the nal connection on the engine block of
the stalled machine (not to the negative battery
post), away from the battery , and stand back
( Figure 71 ).
g024213
g0131 17
Figure 71
1. Engine block
2. Negative (–) cable
7. Start the machine and remove the cables in
the reverse order of connection (disconnect the
negative cable from the engine block rst).
54