Toro 72923 - Page 75

5. Place a drain pan under the lter , remove the old
lter , and wipe the surface clean ( Figure 1 12 ).
g008968
Figure 1 12
Bottom view of the machine
1. Filter locations
2. Hydraulic lter
6. Apply a thin coat of hydraulic uid to the rubber
gasket on the replacement lter ( Figure 1 12 ).
7. Install the replacement hydraulic lter .
8. Install the pump-drive belt and the mower belt.
9. Remove the jack stands and lower the machine
( Figure 1 1 1 ).
10. Add uid to the hydraulic reservoir and check
for any leaks.
1 1. Clean up any spilled uid.
12. Start the engine and let it run for about 2 minutes
to purge air from the system.
13. Shut of f the engine and check for leaks.
14. Check the uid level while the uid is cold.
15. If required, add uid to the hydraulic reservoir .
Note: Do not overll.
75