GEAR DRIVE SYSTEM
5-13LX Lawn Tractor Service Manual
5
7. Slide the wheel onto the axle (Fig. 481).
9. Lower the machine so all tires are on the ground.
10. Install the hub cap (Fig. 483).
Fig 481 PICT-9611
Fig 483 PICT-9608
11. Check the brake operation. Refer to “Brake Adjust-
ment – Gear Drive” following.
8. Install the washer and bolt securing the wheel to the
axle (Fig. 482).
Fig 482 PICT-9609
6. Insert a .011” (.28mm) feeler gauge in between
the outer puck and the disc. Tighten or loosen the
adjusting hex nut until the proper gap is achieved
(Fig. 480).
Fig 480 PICT-9660
To Next Page
Loading...
