Toro Multi Pro 5800-G - Installing the Forward Heat Shield; Removing the Undercarriage Shroud

InstallingtheForwardHeatShield
1.Aligntherearangeoftheforwardheatshield
overtheforwardangeoftherearheatshield
(Figure63).
g028177
Figure63
1.Frontofthemachine3.Rearange(forwardheat
shield)
2.Hex-headboltsand
washers
4.Forwardange(rearheat
shield)
2.Aligntheholesintheforwardheatshieldwith
thethreadedholesinthechassis(Figure63).
3.Assembletheforwardheatshieldtothemachine
withthe6hex-headboltsand6washers(Figure
63)thatyouremovedinstep3ofRemovingthe
ForwardHeatShield(page50).
4.Torquetheboltsto1978to2542N∙cm(175to
115in-lb).
5.Removethejackstandsandlowerthemachine.
RemovingtheUndercarriage
Shroud
1.Removethe5ange-headbolts(5/16x7/8
inch)and5washers(5/16inch)thatsecurethe
rearoftheundercarriageshroudtothechassis
ofthemachine(Figure64).
Note:Retaintheange-headboltsand
washersforinstallationinstep5ofInstallingthe
UndercarriageShroud(page52).
g189584
g189585
Figure64
1.Flange-headbolts(5/16x
7/8inch)
3.Washers(5/16inch)
2.Undercarriageshroud
4.Frontofthemachine
2.Removethe4angelocknuts(5/16inch)from
theboltsandcarriageboltthatsecurethe
mountingtabsoftheundercarriageshroud
totheengine-mountbracketsofthemachine
(Figure65).
Note:Donotremovetheboltsfrom
themachine.Retaintheangelocknuts
forinstallationinstep3ofInstallingthe
UndercarriageShroud(page52).
51