Toro Multi Pro 5800-G - Installing the Undercarriage Shroud; Removing the Seat-Base-Access Panel

g189583
Figure65
1.Enginemount
4.Flangelocknuts(5/16
inch)
2.Bolt—shownforclarity;do
notremove
5.Frontofthemachine
3.Mountingtabs
(undercarriageshroud)
3.Movethemountingtabsofftheboltsthatsecure
theundercarriageshroudtotheengine-mount
brackets.
4.Removetheundercarriageshroudfromthe
machine(Figure64andFigure65).
InstallingtheUndercarriage
Shroud
1.Aligntheundercarriageshroudtothebottom
chassisofthemachine;refertoFigure65in
RemovingtheUndercarriageShroud(page51).
2.Movethemountingtabsoftheundercarriage
shroudovertheboltsandcarriageboltatthe
engine-mountbracketsofthemachine;refer
toFigure65inRemovingtheUndercarriage
Shroud(page51).
3.Assembletheundercarriageshroudtothe
engine-mountbracketsandbolts(Figure
65)withthe4angelocknuts(5/16inch)
thatyouremovedinstep2ofRemovingthe
UndercarriageShroud(page51).
4.Aligntheholesintherearpartofthe
undercarriageshroudwiththeholesinthe
chassis;refertoFigure64inRemovingthe
UndercarriageShroud(page51).
5.Assembletherearpartoftheundercarriage
shroudtothechassis(Figure64)withthe
5ange-headbolts(5/16x7/8inch)and5
washers(5/16inch)thatyouremovedinstep1
ofRemovingtheUndercarriageShroud(page
51).
6.Torquethenutsandboltsto1129to1582N∙cm
(100to140in-lb).
RemovingtheSeat-Base-Access
Panel
1.Removethe2anged-headboltsthatsecure
theseat-base-accesspaneltotheseatbase
(Figure66).
g032998
Figure66
1.Seat-base-accesspanel3.Hole(seatbase)
2.Flanged-headbolt
2.Removetheseat-base-accesspanelfromthe
machine(Figure66).
InstallingtheSeat-Base-Access
Panel
1.Aligntheholesintheseat-base-accesspanel
withtheholesintheseatbase(Figure66).
2.Assembletheseat-base-accesspaneltothe
seatbasewiththe2anged-headbolts(Figure
66)thatyouremovedinstep1ofRemovingthe
Seat-Base-AccessPanel(page52).
3.Torquetheboltsto1975to2542N∙cm(175to
225in-lb).
52