Toro Reelmaster 5010- H - Mow;Transport Switch

Reelmaster 5010- H Page 5 - 45 Electrical System
Mow/Transport Switch
The mow/transport switch is a normally closed proximity
switch that is attached to the bottom of the floor platform
(Fig. 30).
When the mow stop lever is in the MOW position, the tab
on the mow stop lever is positioned away from the target
end of the mow/transport switch so the switch is closed.
The tab on the m ow stop lever is moved next to the mow/
transport switch when the mow stop lever is in the
TRANSPORTpositioncausingtheswitchtoopen.
Adjustment
The distance between the mow/transport switch and the
tab on the mow stop lever should be from 0.094” to
0.100” (2.4 to 2.5 mm) when the mow stop lever is in the
TRANSPORT position. If distance is incorrect, loosen
jam nuts that secure brake switch to frame bracket.
Position switch with jam nuts to allow correct clearance
between switch and mow stop lever. Jam nuts should be
torqued from 162 to 198 in- lb (18.4 to 22.4 N- m).After
jam nuts a re tightened, make sure that clearance has
not changed a nd that mow stop lever does not contact
switch as it is moved between positions.
After adjustment to the mow/transport switch, use the
InfoCenter Display to verify that mow/transport switch
and circuit wiring are functioning correctly (see Diag-
nostics Screen (Hi/Low Range item) in the InfoCenter
Display section of this chapter).
1. Traction pedal
2. Mow stop lever
3. Mow/transport switch
4. Lever tab
5. Lock washer (2 used)
6. Jam nut (2 used)
Figure 30
2
1
3
FRONT
LED location
3
6
5
4
Electrical
System