Reelmaster 5010- H Page 5 - 65 Electrical System
Diode Assembly
A diode assembly is used in the Reelmaster main wire
harness (Fig. 62). The diode is used for circuit protection
from voltage spikes that occur when the starter solenoid
is de- energized.
Testing
1. Park the machine on a level surface, engage the
parking brake, lower the cutting units and stop the en-
gine. Remove the key from the ignition switch.
2. Locate diode assembly near alternator on engine
and remove cable tie that secures diode to wire harness.
Unplug the diode from the wire harness for testing.
3. The diode (Fig. 63) can be tested using a digital
multimeter (diode test or ohms setting) and the table be-
low.
Multimeter
Red Lead (+)
on Terminal
Multimeter
Black Lead (- )
on Terminal
Continuity
Female Male YES
Male Female NO
4. If testing determines that diode is faulty, replace
diode assembly.
5. After diode testing is complete, make sure that diode
is fully installed into wire harness connector and se-
cured to harness with cable tie.
1. Main wire harness 2. Diode assembly
Figure 62
1
2
Figure 63
1. Diode
2. Male terminal
3. Female terminal
1
2
3
Electrical
System
To Next Page
Loading...
