Reelmaster 5010- HPage 3 - 18Kubota Diesel Engine
Engine Bellhousing Assembly
Figure 14
1. Diesel engine
2. Motor/generator assembly
3. Flange head screw
4. Collar
5. Coupler hub
6. W oodruff key
7. Bellhousing
8. Cap screw (2 used)
9. Flat washer (2 used)
10. Flange head screw (7 used)
11. Flange nut (2 used)
12. R- clamp (for generator wire harness)
13. Clamp (for fuel return hose)
14. Caplug
15. Flange head screw (6 used)
16. Dowel pin (2 used)
17. Coupler flange
18. Socket head screw (3 used)
19. Muffler bracket
20. Flange head screw (4 used)
3
9
10
11
5
4
13
2
6
8
1
7
12
14
15
16
17
18
19
20
FRONT
RIGHT
50 to 60 ft- lb
(68to81N-m)
25 to 31 ft- lb
(34to42N-m)
Antiseize
Lubricant
Antiseize
Lubricant
The 48 VDC motor/generator is attached to the engine
bellhousing with six (6) flange head screws. Access to
these screws requires the bellhousing and motor/gener-
ator to be removed from the engine as an assembly. For
recommended procedures to remove the bellhousing
and motor/generator assembly from the engine, see 48
VDC Motor/Generator Assembly in the Service and Re-
pairs section of Chapter 5 - Electrical System.
To Next Page
Loading...
