Reelmaster 5010- HGroomer Page 8 - 2
General Information
Groomer Kit Installation Instructions
The groomer kit installation instructions provides infor-
mation regarding the installation, set- up and operation
of the optional groomer on your Reelmaster machine.
Refer to this publication for additional information when
servicing the groomer.
48 VDC Battery Disconnect
CAUTION
Before installing, removing or servicing compo-
nents in the 48 VDC system (e.g. cutting unit mo-
tors, motor/generator), separate the 48 VDC bat-
tery discon nect. This will prevent unexpected
operation of 48 VDC system components.
The 48 VDC battery disconnect is attached to the right
frame rail under the operator seat (Fig. 1). Unplug the
disconnect to make sure that 48 VDC components do
not operate unexpectedly. Apply dielectric grease to the
contact surfaces of the battery disconnect and plug the
battery disconnect back in after service to the 48 VDC
system is completed.
1. RH frame rail 2. 48V battery disconnect
Figure 1
2
1
FRONT
To Next Page
Loading...
