Toro Reelmaster 5010- H - Special Tools

Reelmaster 5010- H
Cutting Units
Page 7 - 4
Special Tools
Order special tools for your Reelmaster from your Toro
Distributor. Some tools may have been supplied with
yourmachineorareavailableasToroparts.
Gauge Bar Assembly
Toro Part Number: 108- 6715
Use gauge bar to verify height- of- cut adjustment. Also
used for adjustment of optional groomer.
Figure 3
Used for Height- of-
Cut adjustment
groomer
adjustment
Used for
Cutting Reel Shim
Toro Part Number: 125- 5611
The cutting reel shim (0.002”) is used to help parallel the
bedknife and cutting reel.
Figure 4
Cutting Performance Paper
Toro Part Number: 125- 5610
Cutting performance paper is used to test the cutting
reel performance after adjusting the reel to bedknife
clearance. 10 packs (30 strips per pack) of cutting per-
formance paper are included in this part number.
Figure 5