Reelmaster 5010- H
Cutting Units
Page 7 - 5
Bedknife Screw Tool
Toro Part Number: TOR510880
This screwdriver- type bit is made to fit Toro b edknife at-
tachingscrews.Usethisbitwithatorquewrenchtose-
cure the bedknife to the bedbar.
IMPORTANT: To prevent damage to the bedbar, DO
NOT use an air or manual impact wrench with this
tool.
Figure 6
Handle Assembly
Toro Part Number: 29- 9100
For applying lapping compound to cutting units while
keeping hands a safe distance from the rotating reel.
Components for the handle assembly are available indi-
vidually as follows:
Brush 36- 4310
Handle 29- 9080
Handle cap 2410- 18
Figure 7
Cutting Unit Kickstand
Toro Part Number: 119- 8010- 03
The cutting unit kickstand is used to prop up the rear of
the cutting unit during service. Use o f this tool stabilizes
the cutting unit and prevents the bedbar adjusting
screws from resting on the work surface.
Figure 8
Cutting
Units
To Next Page
Loading...
