Toro Reelmaster 5010- H - Chapter 7 Cutting Units

Reelmaster 5010- H
Cutting Units
Page 7 - 1
Chapter 7
Cutting Units
Table of Contents
SPECIFICATIONS 2............................
GENERAL INFORMATION 3.....................
Cutting Unit Operator’s Manual 3...............
48 VDC Battery Disconnect 3..................
SPECIAL TOOLS 4.............................
FACTORS THAT CAN AFFECT CUTTING
PERFORMANCE 8............................
SET UP AND ADJUSTMENTS 12.................
Characteristics 12.............................
Leveling Rear Roller 13........................
SERVICE AND REPAIRS 14.....................
Cutting Reel Motor 14.........................
Backlapping 15...............................
Bedbar Assembly 16..........................
Bedknife Replacement and Grinding 18..........
Bedbar Adjuster Service 20....................
Cutting Reel Assembly Removal and Installation 22
Reel Assembly Removal 22..................
Reel Assembly Installation 24................
Cutting Reel Assembly Service 26..............
Preparing Reel for Grinding 28.................
Front Roller 30...............................
Rear Roller 31................................
Roller Service 32.............................
Rear Roller Brush (Optional) 34.................
Rear Roller Brush Drive System (Optional) 36....
Cutting
Units