Reelmaster 5010- H GroomerPage 8 - 3
Special Tools
Order Special Tools from your Toro Distributor. Some
tools may have been supplied with your machine or are
available as Toro parts.
Spline Insert Tool
Toro Part Number: TOR41 12 (8 tooth for 5 inch reels)
TOR4074 (9 tooth for 7 inch reels)
Use spline insert tool for rotating cutting reel when motor
is removed. Also use this tool for installation of threaded
inserts into cutting reel shaft.
Figure 2
Pulley Alignment Tool
Toro Part Number: 114- 5446
Use pulley alignment tool to verify alignment of groomer
drive and driven pulleys.
Figure 3
Gauge Bar Assembly
Toro Part Number: 108- 6715
Use gauge bar to verify height- of- cut adjustment. Also
used for adjustment of optional groomer.
Figure 4
Used for Height- of-
Cut adjustment
groomer
adjustment
Used for
Groomer
To Next Page
Loading...
