Reelmaster 5010- H
Cutting Units
Page 7 - 16
Bedbar Assembly
1. Bedbar assembly
2. Flange bushing (2 used)
3. Plastic washer (4 used)
4. Metal washer (2 used)
5. Bedbar pivot bolt (2 used)
6. Lock nut (2 used)
7. Lock nut (2 used)
8. Compression spring (2 used)
9. Washer (2 used)
10. Bedbar adjuster screw (2 used)
11. Cutting unit frame
12. RH side plate
13. Cutting reel assembly
14. LH side plate
Figure 21
7” CUTTING REEL SHOWN
FRONT
RIGHT
Antiseize
Lubricant
2
3
6
8
9
10
11
13
1
5
7
12
14
4
3
Bedbar Removal (Fig. 21)
1. Position machine on a clean and level surface, lower
cutting units, stop engine, engage p arking brake and re-
move key from the ignition switch.
2. To prevent unexpected reel motor operation, discon-
nect motors from the electrical power supply by unplug-
ging the 48 VDC battery disconnect (see 48 VDC
Battery Disconnect in the General Information section of
this chapter).
3. Remove the cutting unit from the machine. Use the
cutting unit kickstand to support the cutting unit (see
Special Tools in this chapter).
4. Loosen the lock nuts (item 7) on the end of each bed -
bar adjuster assembly until washer (item 9) is loose.
5. Loosen the lock nuts (item 6) on each bedbar pivot
bolt (item 5).
To Next Page
Loading...
