Toro Reelmaster 5010- H - Page 257

Reelmaster 5010- H Page 6 - 19 Chassis
Disassembly (Fig. 13)
1. Park machine on a level surface, lower cutting units,
stop engine and engage parking brake. Remove key
from ignition switch.
2. Loosen latches and remove access cover from out-
side of control arm.
3. At front of control arm, remove screw (item 28) and
lock nut (item 23) that secure control a rm covers to each
other.
4. Remove five (5) washer head screws (item 12) that
secure each cover to control arm.
5. Remove control arm covers from machine. As LH
control arm cover (item 16) is removed f rom control arm,
unplug wire harness connector from headlight switch.
6. Remove electrical components from control arm as
needed using Figure 13 as a guide.
Assembly (Fig. 13)
1. Install a ll removed electrical components to control
arm using Figure 13 as a guide.
2. Position covers to control arm. As LH cover (item 16)
is placed, plug wire harness connector to headlight
switch. Also, make sure that wire harness is routed cor-
rectly through cover openings (shown in Fig. 14).
3. Secure each cover to control arm with five (5) washer
head screws (item 12). Install screw (item 28) and lock
nut (item 23) to secure covers at front of control arm.
4. Install access cover to outside of control arm.
1. Wire harness 2. Harness foam seal
Figure 14
1
2
Chassis