ChassisPage 6 - 5
Sand Pro 2040Z
Removal (Fig. 1)
1. Park machine on a level surface, lower rear attach-
ment, stop engine, apply parking brake and remove key
from ignition switch.
CAUTION
When changing attachments, tires or perform-
ing other service, use correct jacks, hoists and
supports. Make sure machine is parked on a sol-
id, level surface such as a concrete floor. Prior to
raising machine, remove any attachments that
may interfere with the safe and proper raising of
the machine. Always chock or block wheels. Use
jack stands to support the raised machine. If the
machine is not properly supported by jack
stands, the machine may move or fall, which
may result in personal injury.
2. Chock front wheel to prevent machine from shifting.
Using a jack or hoist, raise machine so rear wheel is off
ground. Support machine with jack stands (see Jacking
Instructions in Chapter 1 - Safety).
3. Remove four (4) lug nuts and remove rear wheel.
Installation (Fig. 1)
1. Install rear wheel and secure with four (4) lug nuts.
2. Lower machine to ground.
WARNING
Failure to maintain proper wheel lug nut torque
could result in f ailure or loss of wheel and may
result in personal injury.
3. Torque lug nuts evenly in a crossing pattern from 70
to 90 ft- lb (95 to 122 N- m).
Chassis
To Next Page
Loading...
