Toro Sand Pro 2040Z - Hydraulic Control Manifold Service

Page 4 - 34Hydraulic System
Sand Pro 2040Z
Hydraulic Control Manifold Service
1. Manifold
2. Hydraulic oil filter
3. Check valve
4. Nut
5. Solenoid coil (raise function)
6. Coil spacer
7. Solenoid coil (lower function)
8. Solenoid valve
Figure 30
2
3
6
8
1
5
7
4
60 in- lb
(6.7 N- m)
20 ft- lb
(27 N- m)
25 ft- lb
(34 N- m)
NOTE: The ports on the control manifold are marked
for easy identification of components. Example: P is the
oil supply connection port and PC is the check valve loc-
ation (see Hydraulic Schematic in this Chapter to identi-
fy the function of the hydraulic lines and cartridge valves
at each manifold port).