Toro Sand Pro 2040Z - Transmission Control Assembly

Page 4 - 40Hydraulic System
Sand Pro 2040Z
Transmission Control Assembly
1. Flange nut (5 used per side)
2. Rear pump linkage assembly
3. Motion control damper
4. Jam nut
5. Leaf spring
6. Flange nut
7. Spring washer (2 used per side)
8. Flat washer
9. Traction switch
10. Carriage bolt
11. Threaded hub
12. Flange head screw (2 used per side)
13. Motion control (LH shown)
14. Flat washer
15. Flange nut (2 used per side)
16. Motion control handle (LH shown)
17. Motion handle (LH shown)
18. Cap screw (2 used per side)
19. Cap screw
20. Flange bushing (4 used per control)
21. Transmission traction lever
Figure 33
FRONT
RIGHT
2
3
6
8
9
10
11
13
1
5
7
12
14
15
16
17
18
19
20
4
20
1
1
12
21
15 to 19 ft- lb
(21 to 25 N- m)
10 to 16 ft- lb
(14 to 21 N- m)
Disassembly (Fig. 33)
1. Park machine on a level surface, lower rear attach-
ment, stop engine, apply parking brake and remove key
from ignition switch.
2. Disassemble transmission control components as
needed using Figure 33 as a guide.
A. If needed, control cover can b e removed to ac-
cess control components for disassembly (Fig. 34).
Remove four (4) flange head screws and lift control
cover from machine.
B. If motion control handle (item 16) is removed,
note orientation of spring washers for assembly pur-
poses (shown in Fig. 35).
1. Motion control handle
2. Control cover
3. Screw (4 used)
Figure 34
2
1
3