Page 5 - 5 Electrical SystemSand Pro 2040Z
Troubleshooting
CAUTION
Remove all jewelry, especially rings and
watches, before doing any electrical testing or
troubleshooting.
For effective troubleshooting and repairs, there must be
a good understanding of the electrical circuits and com-
ponents used on this machine ( see Electrical Schematic
and Wire Harness Drawings in Chapter 7 - Electrical
Drawings).
NOTE: See the Kawasaki FX481V Service Manual at
the end of Chapter 3 - Engine for troubleshooting of en-
gine electrical components.
If the machine has any interlock switches by- passed,
they must be reconnected for proper troubleshooting
and safety.
Starting Problems
Problem Possible Causes
Nothing happens when start attempt is made. Motion control handles are not in neutral locked
position.
Parking brake is not applied.
Battery is discharged or faulty.
Fuse F1 (20 amp) is open, loose or missing.
Battery cables are loose or corroded.
One or both of the traction neutral switches is
improperly installed or faulty.
Traction neutral switch circuit wiring is faulty.
Parking brake switch circuit wiring is faulty.
Wiring to starting circuitry components is loose,
corroded or damaged (see electrical schematic and
wire harness drawings in Chapter 7 - Electrical
Drawings).
Ground connection to frame is loose or corroded.
Start relay is faulty.
Fuseblockisfaulty.
Ignition switch is faulty.
Starter solenoid (attached to starter motor) is faulty.
Starter motor is faulty.
Electrical
System
To Next Page
Loading...
