Toro Sand Pro 2040Z - Transmissions

Page 4 - 46Hydraulic System
Sand Pro 2040Z
Transmissions
1. Engine
2. Carriage bolt
3. Flange head screw (16 used)
4. Belleville washer (4 used)
5. Cap screw (4 used)
6. V- belt
7. Pulley
8. Pump idler assembly
9. Extension spring
10. Crossmember
11. Flange nut (17 used)
12. LH transmission assembly
13. Lock nut (2 used)
14. Bypass valve lever (2 used)
15. Cap screw (2 used)
16. RH transmission assembly
17. Flange head screw (4 used)
18. Socket head screw (2 used)
19. Square key
Figure 42
FRONT
RIGHT
27 to 33 ft- lb
(37to44N-m)
2
3
6
8
9
10
11
13
1
5
7
12
14
15
16
17
18
19
4
11
WARNING
The engine, transmissions and hydraulic compo-
nents can become very hot and cause severe
burns. Allow the machine components to cool
completely before removing the transmission
from the machine.
Removal (Fig. 42)
1. Park machine on a level surface, lower rear attach-
ment, stop engine, apply parking brake and remove key
from ignition switch.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the this section.