Page 5 - 3 Electrical SystemSand Pro 2040Z
Special Tools
Order special tools f rom your Toro Distributor. Some
tools may also be available from a local supplier.
Multimeter
The multimeter can test electrical components and cir-
cuits for current (amps), resistance (ohms) or voltage.
Obtain this tool locally.
NOTE: Toro recommends the use of a DIGITAL Volt-
Ohm- Amp m ultimeter when testing electrical circuits.
The high impedance (internal resistance) of a digital me-
ter in t he voltage mode will make sure that excess cur-
rent is not allowed through the meter. This e xcess
current can cause damage to circuits not designed to
carry it.
Figure 1
Dielectric Gel
Dielectric gel should be used to prevent corrosion of un-
sealed connection terminals. To ensure complete coat-
ing of terminals, liberally apply gel to both component
and wire harness connector, plug c onnector to compo-
nent, unplug connector, reapply gel to both surfaces and
reconnect harness connector to component. Connec-
tors should be thoroughly packed with gel for effective
results.
Do not use dielectric gel on sealed connection terminals
as the gel can unseat connector seals during assembly.
Toro Part Number: 107- 0342
Figure 2
Battery Terminal Protector
Aerosol spray that should be used on battery terminals,
ring terminals, and fork terminals to reduce corrosion
problems. Apply battery terminal protector to the con-
nection after the battery cable, ring terminal, or fork ter-
minal has been secured.
Toro Part Number: 107- 0392
Figure 3
Electrical
System
To Next Page
Loading...
