Toro Sand Pro 2040Z - Page 119

ChassisPage 6 - 13
Sand Pro 2040Z
Removal (Fig 10)
1. Park machine on a level surface, lower rear attach-
ment, stop engine, apply parking brake and remove key
from ignition switch.
2. Remove rear attachment from machine.
3. Remove washer head screw that secures pivot pin
(item 8) to groomer lift frame. Slide pivot pin from frame
and lift cylinder. Separate lift cylinder from lift frame.
4. Remove groomer lift frame from machine:
A. Support lift frame to prevent it from falling during
removal.
B. Remove two ( 2) cap screws (item 9), lock nuts
(item 1) and flat washers (item 2) that secure lift
frame to machine.
C. Remove lift frame from machine.
5. If required, remove pivot sleeves and flange bush-
ings from groomer lift frame.
Installation (Fig 10)
1. If removed, press new flange bushings and pivot
sleeves into groomer lift frame.
2. Install groomer lift frame to machine frame:
A. Position lift frame to machine frame.
B. Secure lift frame with two (2) cap screws (item 9),
lock nuts (item 1) and flat washers (item 2). Torque
lock nuts from 135 to 165 ft- lb (184 to 223 N- m).
3. Position lift cylinder clevis to groomer lift frame. Slide
pivot pin (item 8) into frame and lift cylinder. Secure pivot
pin to lift frame with washer head screw.
4. Lubricate groomer lift frame grease fittings.
5. Install rear attachment to machine.
Chassis