Operating the Hopper (continued)
G377044
1. Position the machine where you intend to
dump the load.
2. Rotate the hopper left or right by pushing the
left or right side of the swivel switch
.
3. Dump the hopper by pushing the top of the
dump switch
.
4. Lower the hopper by pushing the bottom of the
dump switch
.
Note: If you hold the bottom of the switch for 1
second, the hopper fully lowers automatically.
After Operation
After Operation Safety
General Safety
• Engage the parking brake, shut off the engine, remove the key (if applicable), and wait
for all movement to stop before adjusting, cleaning, or repairing the machine.
• Do not touch parts that may be hot from operation. Allow them to cool before attempting
to maintain, adjust, or service the machine.
• Clean debris from drives, mufflers, and the engine to help prevent fires. Clean up oil or
fuel spills.
• Use care when loading or unloading the machine into a trailer or truck.
Removing Debris from the Machine
1. Park the machine on a level surface, move the motion-control levers to the NEUTRAL-LOCK
position, engage the parking brake, and lower the hopper.
2. Shut off the engine and remove the key. Allow the engine to cool.
3. Clean the inside of the hopper using a hose.
IMPORTANT
Do not use a hammer to remove material from the inside of the hopper; this may
cause damage to the machine.
4. Clean any debris from under the hopper.
3462-915A Page 4–8 Operation: After Operation
To Next Page
Loading...
Need help?
General
