Controls Maintenance
Adjusting the Motion-Control Levers
If the motion-control levers do not align horizontally, adjust the right side motion-control
lever.
1. Park the machine on a level surface, lower the hopper, engage the parking brake, shut
off the engine, and remove the key.
2. Push the motion-control levers down out of the N
EUTRAL-LOCK position.
3. Check if the right motion-control lever aligns horizontally with the left motion-control
lever.
G009436
Left motion-control lever
Right motion-control lever in the
Neutral-lock position
Check the horizontal alignment
here
Right motion-control lever
G189389
4. Release the cushion from the rear of the
machine.
5. Loosen the nut
holding the cam .
6. Adjust the cam until it aligns with the left
motion-control lever and tighten the nut for the
cam.
Note: Moving the cam clockwise (in the
vertical position) lowers the handle; moving the
cam counterclockwise (in the vertical position)
raises the handle.
IMPORTANT
Ensure that the flat portion of the cam does not go above a vertical position (right or
left); otherwise you may damage the switch.
7. Repeat Step 2 through Step 6 for the left motion-control lever.
Maintenance: Controls Maintenance Page 5–21 3462-915 A
To Next Page
Loading...
