Replacing a Fuse
The electrical system is protected by fuses and requires no maintenance. If a fuse blows,
check the component or circuit for a malfunction or short.
G376375
Main power fuse (15 A)
Auxiliary power fuse (15 A)
Logic fuse (7.5 A)
1. Release the cushion from the rear of the machine.
2. Pull out the fuse to remove or replace it.
3. Install the cushion to the rear of the machine.
Note: Ensure that the correct-size fuse is installed.
If a fuse blows a second time, check the component/circuit for a malfunction or a short or
contact your Authorized Service Dealer.
Drive System Maintenance
Track Service
Cleaning the Tracks
1. Park the machine on a level surface, move the motion-control levers to the NEUTRAL-LOCK
position, engage the parking brake, and lower the hopper.
2. Shut off the engine, and remove the key. Allow the engine to cool.
3. Lift/support the side of the machine to be worked on so that the track is 7.6 to 10 cm (3
to 4 inches) off the ground.
Maintenance: Electrical System Maintenance Page 5–15 3462-915 A
To Next Page
Loading...
