Workman GTX Electric
Transaxle
Page 4 -- 6
3. Install both rear wheel hubs and wheels to the vehi-
cle ( see Rear Wheel and Hubs in the Service and Re-
pairs section of Chapter 5 -- Chassis). Make sure that
fasteners for wheel h ubs, brake calipers and wheels are
properly torqued during assembly.
4. Lower vehicle to ground.
5. Apply antiseize lubricant to the splines of the trans-
axle and motor shafts.
6. Install traction motor to transaxle (see Traction Motor
in the Service and Repairs section of Chapter 3 -- Electri-
cal System).
7. Make sure that transaxle is filled with 0.7 quarts (0.66
liters) of new SAE 10W--30 motor oil.
8. Install cargo bed to the frame (see Cargo Bed in the
Service and Repairs section of Chapter 5 -- Chassis).
9. Connect the conductors between the battery pack
and vehicle components (see Opening Battery Circuit in
the General Information section of Chapter 3 -- Electrical
System). Make sure to torque hex nuts on battery termi-
nals from 95 to 105 in--lb (10.8 to 11.8 N--m).
10.After connections are made, apply Toro battery ter-
minal protector (see Special Tools) to all battery posts
and cable connectors on traction motor to prevent corro-
sion. Make sure that cable terminal boots are positioned
over all connections.
11. Check brakes for proper operation.
To Next Page
Loading...
Need help?
General
