Workman GTX Electric TransaxlePage 4 -- 11
D. Apply light oil or grease to the inner lip of the oil
seal and insert the shaft and bearing assembly into
the axle housing. Align the axle shaft splines with
those in the differential assembly and drive the axle
shaft and bearing assembly into the axle housing.
Use a bearing driver against the outer race of the
bearing and continue until the bearing seats against
the inner retaining ring.
E. Install the outer snap ring.
F. Repeat procedure for opposite side.
5. Fill the transaxle with 0.7 quarts (0.66 liters) of new
SAE 10W--30 motor oil.
Transaxle
To Next Page
Loading...
Need help?
General
